Navigation

Airport Projects

Geotechnical Investigation Report, which included 64 borings and 15 test pits, laboratory testing, and earthwork recommendations.
Mass grading and Storm Drain for Grading and Drainage Package
Construct Finish Grading Project, including grading for the Terminal and ARFF Building Pads, Apron, remaining VSR, FBO, GA, and Runway Safety Areas.
Construct Airport Landside Culinary Waterline

Rehabilitated Runway 16/34 by rotomilling 3 inches of pavement, laying a new 3 inch surface course, adjusting runway lighting to meet safety standards, and re-grading safety area
Constructed three new taxilanes on the west side of the airport
Constructed terminal apron, northwest, northeast, and east mid-field aprons
Constructed 3,800 foot parallel taxiway “B”
Rehabilitated the MIRL and MITL on taxiways “A” & “B” and runway
Rehabilitated Runway 16/34 requiring crack sealing and pavement overlays, including crumb rubber hot plant mix, latex rubber friction courses

Reconstructed Runway 03/21, the primary ILS Runway, using in-place pulverization, excavation, incorporating frost protection, and installing runway shoulder drainage.
Reconstructed Runway 16/34 utilizing in-place pulverization, soil stabilization, re-grading, and a bituminous surface course
Constructed the runway safety area and ILS critical area grading for a new ILS installation Designed and reconstructed Runway 16/34 utilizing in-place pulverization, soil stabilization, re-grading, and a bituminous surface course
Overlaid Runway 16/34 with an open-graded porous friction course
Reconstructed the airport terminal apron using Portland cement concrete to meet higher aircraft weight requirements.
Constructed two new taxilanes in southeast hangar area
Rehabilitated five tie-down and holding aprons
Constructed new parking apron for Kemp facility

Constructed 1,400 foot Runway 16 extension
Rehabilitated Runway 16-34
Constructed a new full length parallel taxiway and connectors
Constructed runway and taxiway subsurface and side drainage system
Constructed runway and taxiway storm drain system with pump stations
Constructed a new taxilane for the north and south aprons
Constructed new aircraft apron
Widened runway 16/34 from 75' to 100' using soil stabilization techniques
Constructed new category B-II runway safety area using soil stabilization techniques

Currently constructing Runway 16/34, Taxiways, Apron, and Access Road Grading, consisting of approximately 500,000 cubic yards of P-152 Embankment
Construct 1,500 lineal feet of D-701 Storm Drain Pipe
Construct 19,500 lineal feet of D-705 Pipe Underdrain along edges of future runway and taxiways

Constructed new Water and Sanitary Sewer pipelines
Currently constructing a temporary airport terminal, fuel tanks, electrical generators, and extensive site concrete work, which includes a large bus turnaround
Grading and Drainage for 5,000 foot Runway 17/53, which includes approximately 166,500 cubic yards of P-152 Excavation and 51,425 square yards of P-209 Crushed Aggregate Base Course

Reconstruct 7,100 foot Runway 5/23 with associated taxiways and apron
Relocate Airport Entrance Road
Construct intersection of relocated Airport Entrance Road and U.S. Highway 160, including acceleration and deceleration lanes meeting ADOT standards

Construct North Hangar Area
Construct Taxi lanes 1 and 2, including P-152 Embankment, P-208 Crushed Aggregate Base Course, and P-401 Asphalt Pavement
Install utility corridor to North Hangar Area

Constructed new 5,700 foot runway and associated taxiways
Constructed new 200 x 700 foot tie-down apron
Constructed new full length parallel taxiway and two connector taxiways between Runway 01/19 and parallel taxiway
Constructed Fuel Farm facility with two, 10,000 gallon tanks, pumping systems, and concrete spill retention basins

Relocated, lengthened, and constructed new 5700 foot category B-II runway
Constructed additional tie-down apron
Rehabilitation of the runway using rotomilling, and a new bituminous surface course